CTC Union GSW-3208M1, Руководство пользователя

Страница: 83 / 240

80
packets forwarding that are matched in static entries on the specific port.
ip-source-guard mode
command is used to enable this function for the ports.
And “
no ip-source-guard mode
” command is used to disable it.
Note: Dynamic IP Source entry is learned from DHCP request. Before
enable IP Source Guard, DHCP Snooping function should be enabled first.
Otherwise, static IP Source entry should be created for IP Source Guard
operation.
18
lacp
command
This command is used to configure LACP protocol working on the interface
port(s).
lacp clear
command is used to clear LACP Statistics.
lacp key [auto | specific x]
command is used to specify the Key value
incurred by the port. The “
auto
” setting will set the key as appropriate by the
physical link speed, 10Mb = 1, 100Mb = 2, 1Gb = 3. Using the “
specific
”
setting, a user-
defined value “
x
” with value 1~65535 can be entered. Ports
with the same Key value can participate in the same aggregation group, while
ports with different keys cannot.
lacp mode
command is used to enable LACP function on the ports. And “
no
lacp mode
” command is used to disable it.
lacp priority x
command is used to set LACP Priority of the port. If the LACP
partner wants to form a larger group than is supported by this device then this
parameter will control which ports will be active and which ports will be in a
backup role. Lower number means greater priority.
lacp role [active | passive]
command is used to set the role of the ports for
LACP operation. The “
active
” will transmit LACP packets each second,
while “
passive
” will wait for a LACP packet from a partner (speak if spoken
to).
lacp timeout [fast | slow]
command is used to configure Timeout to control
the period between L
ACP transmissions. “
fast
” will transmit LACP packets
each second, while “
slow
” will wait for 30 seconds before sending a LACP
packet.
19
lldp
command
This command is used to configure LLDP function for the ports.
lldp clear
command is used to clear LLDP Statistics.
lldp [disable
|
enable | rx-only | tx-only]
command is used to set LLDP
operation mode on the ports.
-
disable
: disable LLDP operation on the ports. The switch will not send out
LLDP information, and will drop LLDP information received from nei ghbours.