CTC Union GSW-3208M1, Руководство пользователя

Страница: 80 / 240

77
)authentication fails or the RADIUS Access -Accept packet no longer carries a
QoS Class or it's invalid, or the supplicant is otherwise no longer present on
the port, the port's QoS Class is immediately reverted to the original QoS
Class (which may be changed by the admini strator in the meanwhile without
affecting the RADIUS-assigned).
This option is only available for single-client modes, i.e.
• Port-based 802.1X
• Single 802.1X
dot1x radius-vlan
command is used to enable RADIUS-Assigned VLAN
function. And “
no dot1x radius-vlan
“ command is used to disable it. When
RADIUS-Assigned VLAN is both globally enabled and enabled for a given
port, the switch reacts to VLAN ID information carried in the RADIUS Access -
Accept packet transmitted by the RADIUS server when a supplicant is
successfully authenticated. If present and valid, the port's Port VLAN ID will be
changed to this VLAN ID, the port will be set to be a member of that VLAN ID,
and the port will be forced into VLAN unaware mode. Once assigned, all traffic
arriving on the port will be classified and switched on the RADIUS -assigned
VLAN ID.
If (re-)authentication fails or the RADIUS Access -Accept packet no longer
carries a VLAN ID or it's invalid, or the supplicant is otherwise no longer
present on the port, the port's VLAN ID is immediately reverted to the original
VLAN ID (which may be changed by the administrator in the meanwhile
without affecting the RADIUS-assigned).
This option is only available for single-client modes, i.e.
• Port-based 802.1X
• Single 802.1X
11
eee
command
This command is used to configure EEE(Energy Efficient Ethernet, defined in
IEEE 802.3az) function for the interface port(s).
eee
command is used to enable this function for the interface port(s). And
“
no eee
” command is used to disable it.
eee queue-list
command is used to select all queues as EEE Urgent
Queues. And “
no eee queue-list
“ command is used to remove all queues
from EEE Urgent Queues. EEE Urgent Queues are Queues set that will
activate tranmission of frames as soon as data is availabl e. Otherwise the
queue will postpone tranmsission until 3000 bytes are ready to be
transmitted.
eee queue-list [x | x,y,z | x-y]
command is used to assign queue(s) to EEE
Urgent Queues.
[x | x,y,z | x-y]
is the queue number with value 1~8. (“x” for
single queue; x,y,z for queue list; x-y for queue range). The original setting
will be lost. “
no eee queue-list
“ command is used to remove all queues
from EEE Urgent Queues List.