CTC Union GSW-3208M1, Руководство пользователя

Страница: 64 / 240

61
• If sFlow is currently configured through SNMP, Owner is a string identifying
the sFlow receiver.
If sFlow is configured through SNMP, all controls are disabled to avoid
inadvertent reconfiguration.
sflow receiver time_out x
command is used to set the Receiver Time_out
for list of receiver ID. “
x
” is the number of seconds remaining before
sampling stops and the current sFlow owner is released. Its valid value is
0~2147483647 in seconds.
sFlow function is enabled by port. And the other sFlow settings on ports are
configured
in “(config-if)#” mode (go with “interface ethernet 1/x” command.
“x” is the port number.) Please refer to “sflow” command in Section 6.2.4.1
for the details.
35
snmp-server
command
This command is used to configure SNMP function of the switch.
Entering “snmp-server ?”, the sub-commands will be shown.
(config)# snmp-server ?
<1-1> Index of Trap
community Defines SNMP community access string
contact Sets the system contact string
enable Enables SNMP function
location Sets the system location string
snmpv3-access Sets the snmpv3 community
snmpv3-community Sets the snmpv3 community
snmpv3-group Sets the snmpv3 group configuration
snmpv3-user Sets the snmpv3 user configuration
snmpv3-view Sets the snmpv3 view configuration
version Sets the snmp version
Entering “snmp-server 1 ?” command, the commands for SNMP Trap
configuration will be shown.
(config)# snmp-server 1 ?
authentication-failure Trap Community
community Trap Community
enable Enables this Trap function
host Specifies SNMP notification operation recipients
host-ipv6 Specifies SNMP notification operation recipients (for ipv6 addresss)
link-up-dow n Trap Link-up and Link-dow n
version Trap Version
snmp-server x authentication-failure
command is used to enable that the
SNMP entity is permitted to generate authentication failure traps. “
x
” is the
index of the trap 1~1. And “
no snmp-server x authentication-