CTC Union GSW-3208M1, Руководство пользователя

Страница: 65 / 240

62
failure
“ command is used to disable it.
snmp-server x community yyy
command is used to set the the community
access string when sending SNMP trap packet. “
x
” is the index of the trap
1~1. “
yyy
” is community string with length is 0 to 255, and the allowed
content is ASCII characters from 33 to 126.
snmp-server x enable
command is used
to enabled this SNMP Trap. “
x
”
is the index of the trap 1~1. And “
no snmp-server x enable
“ command is
used to disable it.
snmp-server x host y.y.y.y
command is used to set the SNMP trap IPv4
destination address. “
x
” is the index of the trap 1~1. “
y.y.y.y
” is a IPv4
address.
snmp-server x host-ipv6 <IPv6 address>
command is used to set the
SNMP trap IPv6 destination address. “
x
” is the index of the trap 1~1.
“
<IPv6 address>
” is a IPv6 address.
snmp-server x link-up-down
command is used to enable SNMP trap link-
up and link-
down mode operation. “
x
” is the index of the trap 1~1. And
“
no snmp-server x link-up-down
” command is used to disable it.
snmp-server x version [v1 | v2c | v3]
command is used to select the
SNMP trap supported version. “
x
” is the index of the trap 1~1. The
options for SNMP Trap version are SNMP V1(v1), SNMP V2c(v2c), and
SNMP V3(v3).
snmp-server community get xxx
command is used to set the community
string of get command for SNMP operation. “
xxx
” is the community string.
snmp-server community set xxx
command is used to set the community
string of set command for SNMP operation. “
xxx
” is the community string.
snmp-server contact xxx
command is used to set the contact information for
this switch. “
xxx
” is the contact information string.
snmp-server enable
command is used to enable SNMP function. And “
no
snmp-server enable
“ is used to disable it.
snmp-server location xxx
command is used to set the location information
for this switch. “
xxx
” is the location information string.
snmp-server version [v1 | v2c | v3]
command is used to select the SNMP
operation version. The options for SNMP version are SNMP V1(v1), SNMP
V2c(v2c), and SNMP V3(v3).
The following commands are for SNMP v3 configuration.
snmp-server snmpv3-access group-name xxx security-model [any | v1 |
v2c | usm] security-level [authnopriv | authpriv | noauthnopriv]
read_view_name yyy write_view_name zzz
command is used to create a
SNMPv3 access entry. “
xxx
” is a
string identifying the group name that
this entry should belong to. The allowed string length is 1 to 32, and the
allowed content is ASCII characters from 33 to 126.
“
yyy
” is the name of the
MIB view defining the MIB objects for which this request may request the
current values. The allowed string length is 1 to 32, and the allowed content is