CTC Union GSW-3208M1, Руководство пользователя

Страница: 70 / 240

67
and could be 1, 2, 4, 8, ..., 512, 1k, 2k, 4k, ..., 512k, 1024k, 2048k, ..., 32768k.
storm-control unicast x
command is used to set unicast flooding traffic
suppression rate. “
x
” is the suppression rate in pps(packet per second),
and could be 1, 2, 4, 8, ..., 512, 1k, 2k, 4k, ..., 512k, 1024k, 2048k, ..., 32768k.
38
tacacs-authentication-server
command
This command is used to configures Authentication Server. Up to
five Authentication Servers are supported. The following is the
details of the command.
Configure the server ...
tacacs-authentication-server x active
command is used to activate
Authentica
tion Server “x”. “
x
” is the server index number between
1~5.
tacacs-authentication-server x host y.y.y.y
command is used to assign IP
address to
Authentication Server “x”. “
x
” is the server index
number between 1~5. “
y.y.y.y
” is a IP address.
tacacs-authentication-server x key yyy
command is used to assign the
secret key “yyy” to Authentication Server “x”. “
x
” is the server index
number between 1~5. “
yyy
” is the secret key - up to 29 characters long -
shared between the Authentication Server and the switch.
tacacs-authentication-server x port y
command is used to assign the TCP
port to use on the
Authentication Server. “
x
” is the server index
number between 1~5. “
y
” is the TCP port number between 0~65535. If the
port is set to 0 (zero), the default port (49) is used.
Configure the operation parameters ...
tacacs-authentication-server dead-time x
command is used to specify
Dead Time of Common Servers. “
x
” is the Dead Time with a number
between 0~3600 seconds.
The Dead Time is the period during which the switch will not send new
requests to a server that has failed to respond to a previous request. This will
stop the switch from continually trying to contact a server that it has already
determined as dead.
Setting the Dead Time to a value greater than 0 (zero) will enable this feature,
but only if more than one server has been configured.
tacacs-authentication-server timeout x
command is used to specifies Time
Out of Common Servers. “
x
” is the Timeout with a number between 3~3600
seconds. The Timeout is the maximum time to wait for a reply from a server.
If the server does not reply within this time frame, we will consider it to be
dead and continue with the next enabled server (if any).
* RADIUS servers are using the UDP protocol, which is unreliable by design.
In order to cope with lost frames, the timeout interval is divided into 3