CTC Union GSW-3208M1, Руководство пользователя

Страница: 32 / 240

29
tag_prio VLAN tag priority
vid Specify vlan id
Here is the details of these sub-commands.
1).
exit
: this command is used to exit the ACL setting.
2).
help
: this command will show all available commands.
3).
history
: this command will list the input command history.
4).
logout
: this command will logout from the command line interface.
5).
quit
: this command will quit from the command line interface.
6).
action
: this command will define the action to premit or deny packets that
match this ACL rule.
action permit
- The frame that hits this ACE is granted permission for the
ACE operation.
action deny
- The frame that hits this ACE is dropped.
7).
destination-mac
: this command is used to specify L2 destination Mac
address of packet for filter matching.
destination-mac any
- No DMAC filter is specified. (DMAC filter status is
"don't-care".)
destination-mac xx-xx-xx-xx-xx-xx
- Specify the destination MAC filter for
this ACE.
8).
frame-type
: this command is used to set Frame Type of packet for filter
matching.
(config-ace-10)# frame-type ?
any Define Frame to any
arp Define Frame to ARP
ethernet-type Ethernet Type: 0x600 - 0xFFFF or 'any' but
excluding 0x800(IPv4) 0x806(ARP) and 0x86DD(IPv6)
ipv4 Define Frame to IPv4 Frame
frame-type any
- Any frame can match this ACE.
frame-type arp
- Only ARP frames can match this ACE. Notice the ARP
frames won't match the ACE with ethernet type.
frame-type ethernet-type
- Only Ethernet Type frames can match this ACE.
The IEEE 802.3 describes the value of Length/Type Field specifications to
be greater than or equal to 1536 decimal (equal to 0600 hexadecimal).
frame-type ipv4
- Only IPv4 frames can match this ACE. Notice the IPv4
frames won't match the ACE with ethernet type.
9).
logging
: this command is used to specify the logging operation of the
ACE. Frames matching the ACE are stored in the System Log. Please
note that the System Log memory size and logging rate is limited.
“
logging
” command can enable this function.
10).
mirror
: this command is used to specify the mirror operation of th e ACE.
Frames matching the ACE are mirrored to the destination mirror port.
“
mirror
” command can enable this function.
11).
next_id
: this command is used to jump to another ACE setting.