Cleco 17BP, Инструкция по эксплуатации

Страница: 9 / 64

Items delivered and storage 3
2291b-en_1_3_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 9
2.3 Intended use
The tool is a part of the APEX tightening system and is exclusively intended for fastening and releasing
threaded fasteners.

Use only in connection with a nutrunner controller of the mPro400GC series and the accessories and
cables approved by APEX.

Only operate with a power supply from APEX.

Do not use as a hammer or for re-bending.

Do not open it or modify it structurally.

Do not use it in areas where there is a risk of explosion.

Only in EMC Limit Class A (electromagnetic immunity for industrial areas).
2.4 Standards
It is mandatory that national, state, and local codes and standards be followed.
12 Technische Daten, Page 58.
2.4.1 FCC conformity
This device complies with Part 15 of the FCC Rules. Operation satisfies the following two prerequisites: (1)
the device does not cause any impermissible failure, and (2) the device accepts failure, including failures
which cause unwanted operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
2.4.2 Canada conformity
Operation satisfies the following two prerequisites: (1) the device does not cause any impermissible failure,
and (2) the device accepts failure, including failures which cause unwanted operation of the device.
2.4.3 EMC, noise, vibration
For the currently observed EMC standards, emission sound pressure levels and vibration values, see the
EC Declaration of Conformity.
3 Items delivered and storage
3.1 Items delivered
Check delivery for transit damage and ensure that all items have been supplied:
1
17BP
1 This instruction manual
1 Declaration of Conformity
1 Factory test certificate for transducers
1 Machine Capability Analysis (MCA)
3.2 Storage
For short-term storage and for protection against damage

Place the tool in the tool holder.
For storage longer than 100 hours