Cleco 17BP, Инструкция по эксплуатации

Страница: 46 / 64

46 P1890E/EN 2013-08
2291e-en_TroubleShooting_bedingt.fm, 25.08.2017
Troubleshooting
10
Occasional interrup-
tions in data commu-
nication. Distance between the
base station and tool
is too great.

Increase the power on the base station and tool or

reduce the distance between the base station and the tool.
Transmission power
is too low.

Increase the power on the base station
and tool.
Excessive data traf-
fic on WLAN Net-
work. Reduce data traffic on WLAN Network.

On the control screen Basic ,
increase the
Initial Tor-
que
.
 On the control screen mPro >
Main Menu > System Pro-
gramming > Special Func-
tions > MWF
, disable the
torque graph data transmis-
sion.

On the control screen mPro >
Main Menu > Application Buil-
der > Settings > Fastening
Stages > Fastening Stage # >
Fastening Sequence
,
increase the
Initial Tor-
que
.
Too many tools on
the same wireless
channel.

Use different channels for different base stations.
Other 2.4 GHz
machines use the
same wireless fre-
quency.

Use a different channel.

Cell planning as per Instruction Manual for the base station
Distance for
wireless transmis-
sion is less than
expected. Transmission power
is too low.

Increase the power on the base station and tool.
Installation location of
the base station is
unsuitable.

Place the base station in a location where there is a clear line of
sight between the base station and the tool.
1) Software-dependent measure. Discrepancy possible when using Custom Tool Software.
Problem Possible cause Measure for mPro400GC
(SW S168813) Measure for mPro400S…
(example SW 168841)
1)
RF15.4 data communication between controller and tool