Cleco 17BP, Инструкция по эксплуатации

Страница: 19 / 64

Initial operation 7
2291b-en_1_3_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 19
6.5 Changing the screw inserts
Fig. 6-2: Screw bits (GETA/APEX recommendation): Connection in accordance with DIN 3126, form E 6.3
(¼" shank).
7 Initial operation
7.1 Carrying out the rundown
Ensure secure position of the power supply before starting the tool. The tool is now ready for operation.

Press and release the start button: Rundown is executed, the LCD display shows Ready.
Types with wireless transmission continuously communicate with the controller. The tool automatically
receives the parameters and, when the rundown is complete, automatically sends the rundown results to
the control system. Programming and setting up the wireless interface port are described in the program-
ming manual of the controller.
Types without wireless transmission must be placed in the tool holder when the rundown is complete. The
rundown results are transmitted and shown under the
Run screen menu item.
7.2 Operating status
The operating modes change in the following order. The following functions are available depending on the
display:
WARNING!
Risk of glove being pulled in due to rotating machine parts.
Risk of fingers being crushed or lost.
 Do not wear gloves when working with this tool.
Operating
status LED
display LCD display Function
Active Continuous light:
Red – Fastening NOK
Green – Fastening OK On screws
Data transmission
1)
After 1 minute idle time automatic switch to:
1) Times are default values and can be programmed in the controller.
Energy saver mode Green flashing light Off Data transmission
Automatic switch to the following after a further 10 minutes:
Sleep Off Off Data transmission not possible
Manual change from Sleep to Active :
Press the start button fully down and hold it for about 1 second.
For manual deactivation of the tool, disconnect the power supply.
1.
2.
1.
2.
Insertion Removal