Cleco 17BP, Инструкция по эксплуатации

Страница: 42 / 64

42 P1890E/EN 2013-08
2291e-en_TroubleShooting_bedingt.fm, 25.08.2017
Troubleshooting
10
Problem Possible cause Measure for mPro400GC
(SW S816813) Measure for mPro400S…
(example SW 816841)
1)
1) Software-dependent measure. Discrepancy possible when using Custom Tool Software.
Infrared data communication between controller and tool
No infrared data com-
munication between
the controller and
tool. Incorrect interface
selected for the con-
nection to the control-
ler.

On the control screen Tool
Setup > Wireless Settings ,
check the correct
IRDA
Connection
.

On the control screen Main
Menu > System Programming
> Service > TMA Configura-
tion
> Communication with
Tool , check the correct
IRDA
Connection
.
 Check whether the tool holder is connected at the selected inter-
face.
Selected interface is
used for serial data
transmission. Do not use the same interface for serial data transmission and infrared
data transmission.
Check on the control screen
Communication > Data Transmis-
sion

Is serial data transmission
activated (selection
RF Mode
is not
None
)?

Is the same interface
selected?

If so, select a different inter-
face or deactivate serial data
transmission.
All tools must be checked.
Check on the control screen Main
menu > System Programming >
Service > TMA Configuration >
Communication with Tool

Is serial data transmission
activated (selection
RF Mode
is not
None
)?

Is the same interface
selected?
 If yes, select another inter-
face under
Main Menu > Sys-
tem Programming < System
Programming > Serial Ports

Disable serial data transmis-
sion.
All tools must be checked.