Cleco 17BP, Инструкция по эксплуатации

Страница: 22 / 64

22 P1890E/EN 2017-06
2291c-enu_LCD_bedingt.fm, 25.08.2017
LCD display
8
8.2 Status display
The status display is divided into the "Standard" and "Linking" modes. "Standard" is selected if "Linking" is
not enabled at the control system
 See
Process Programming Advanced\Linking
). The application is selected at the <Run Screen>
or via the App. selection inputs.
The symbol at the top right shows an interrupted data connection to the control.
No other status messages take priority.
The tool is ready.
Number of remaining rundowns that can still be carried out until the rundown data
memory is full and the rundown data have to be transmitted to the control.
All fastening sequences have been completed.
 Synchronize the tool with the control once again.
No fastening sequences have been initialized.

Synchronize the tool with the control once again.
No fastening sequence parameters have been set.

Check the Application and Tightening group selected on the control to determine
whether the tool settings and process programming have been carried out.
Application locked.

Synchronize the tool with the control once again.
Reject Release active.
The Reject Release was programmed in the control.
 See
Process programming\Advanced\Tool Settings\Reject Release
.
 Depending on the programming, unlock the tool via the external input NOK release or
Release on Backoff. For unlocking via the external input NOK release , set the external
input and synchronize it with the control.
OK
T12.00
A100
Ready
Remain
512
Job
comple
Sync
No
Job
Sync
Parame
not
set
App
locked
Sync
Reject
Releas
Sync