Cleco 17BP, Инструкция по эксплуатации, Страница: 17 / 64

Prior to initial operation 6
2291b-en_1_3_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 17
6 Prior to initial operation
The tool was preset by Apex Tool Group. A setting for your specific fastening sequence must only be made
with the controller or a PC by a qualified person. For more information, refer to the programming manual.
6.1 Setting up tool holder

Mount the tool holder on a stable base.
For tool holder with IrDA interface port:

Select the location in such a way that no outside light shines onto the tool holder.
This can inhibit data transmission.

Lay the connection cable in such a way that there is no danger that persons can trip.
6.2 Charge battery pack
Battery pack is only partly charged upon delivery.

It must be fully charged before initial use. See battery pack instruction manual.
6.3 Changing LMC
NOTE Electrostatically sensitive component. Note handling instructions.
The electronic assemblies of the cordless EC tool can be destroyed or damaged by electrostatic discharge
(ESD). This can lead to immediate failure, or to malfunctions at a later date. To avoid damage when chang-
ing the LMC, make sure that there is a potential equalization between the person and the tool.
Possibly set up equipment in an ESD-protected environment. Recom-
mendation for an ESD workplace: Electrically conductive work surfaces,
anti-static straps, appropriate furniture, clothing and footwear, as well as
grounding of all components.
LMC must only be changed with the battery is disconnected.
Removing LMC
 Remove the battery.
 Slacken the screws (M4, DIN 912).

Carefully pull the LMC out of the handle
and replace it.
Graphic: CANESPA