Cleco 17BP, Инструкция по эксплуатации

Страница: 14 / 64

Product description
4
14 P1890E/EN 2017-06
2291b-en_1_3_bedingt.fm, 25.08.2017
4.2.9 LCD display
See 8 LCD display, Page 21
4.2.10 Barcode scanner
For tools of the (...)S series, the built-in barcode scanner is a class 2 laser scanner with a wavelength of
650 nm.
The barcode scanner reads one-dimensional linear barcodes:
Depending on how the control is programmed, there are two different operating modes:
Barcode as release for further rundowns

Press the start button on the tool; this activates the barcode scanner.
The successful scan is acknowledged by an acoustic signal.

Press the start button on the tool again; this starts the rundown.
If is necessary to read another barcode, proceed as follows.
Barcode not necessary as release for further rundowns

From the Scanner tool menu, select Read barcode .

Press the start button on the tool; this activates the barcode scanner.
The successful scan is acknowledged by an acoustic signal.

Press the start button on the tool again; this starts the rundown.
Alternatively: assign the Read barcode function to the left function key <F1> on the tool.

Press the left function key <F1> on the tool once.

Press the start button on the tool again; this activates the barcode scanner.
Programming the barcode scanner is described in the programming manual of the control.
CAUTION!
Eye injury from class 2 laser beam
 Do not look into the laser beam window when the laser is on.

Repair any damage immediately.
Damage of the optical components can cause laser radiation.

Modifications to the barcode scanner and procedures not outlined in this instruction manual are
strictly prohibited.
 Take defective devices out of operation immediately.
Keep window clean.
A dirty window affects the detection rate of the scanner.
Scanning operation Acoustic signal
• Successful 50 ms long
• Faulty
• Not within 3 seconds
• Cancel by releasing the Start button
3 times in rapid succession