Cleco 17BP, Инструкция по эксплуатации

Страница: 44 / 64

44 P1890E/EN 2013-08
2291e-en_TroubleShooting_bedingt.fm, 25.08.2017
Troubleshooting
10
Occasional interrup-
tions in WLAN data
communication. Distance between the
access point and the
tool is too great.

Check the signal strength at the tool in the Wireless Setting sub-
menu.

If necessary, reduce the distance between the access point and
the tool.
The tool is already
assigned to another
control.

Check whether the tool (IP address) is also assigned to another
control.

If yes, delete the assignment in the other control.
A tool can only be assigned to one control.
Excessive data traf-
fic on WLAN Net-
work. Reduce data traffic on WLAN Network.
 On the control screen Basic ,
increase the
Initial Tor-
que
.

On the control screen mPro >
Main Menu > System Pro-
gramming > Special Func-
tions > MWF
, disable the
torque graph data transmis-
sion.
 On the control screen Main
Menu > Application Builder >
Settings > Fastening Stages
> Fastening Stage # > Fas-
tening Sequence
, increase
the
Initial Torque
.
 On the control screen Main
Menu > System Programming
> Special Functions > MWF
,
disable the torque graph data
transmission.
1) Software-dependent measure. Discrepancy possible when using Custom Tool Software.
Problem Possible cause Measure for mPro400GC
(SW S816813) Measure for mPro400S…
(example SW 816841)
1)
WLAN data communication between controller and tool