Cleco 17BP, Инструкция по эксплуатации

Страница: 13 / 64

Product description 4
2291b-en_1_3_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 13

Press the start button all the way down.
4.2.4 Reverse switch
The reverse switch changes the rotation direction of the tool:
Clockwise rotation – for screwing in screws
Press reverse switch as far as it will go.
When the start button is pressed
Active appears on the LCD display.
Counterclockwise rotation – for loosening or screwing out screws
Press reverse switch as far as it will go.
When the start button is pressed
Left appears on the LCD display.
4.2.5 IrDA interface port
The tool communicates with the controller over the tool holder via the IrDA interface port (infrared). For
secure data transmission and for programming, place the tool in the tool holder with IrDA interface port,
Order No. 935999. Data transmission is possible in the Active, Energy-saver mode and
Standby operating
modes, but not possible in Sleep mode (see 7.2 Operating status, Page 19).
4.2.6 Identification – set torque (accessories, optional)
To identify the tool with the set torque, glue the corresponding marking foil to the right and the left of the
LCD display.
4.2.7 LED lighting
LED lighting make it possible to quickly find the screw point.
3 different activation methods are possible. Which is used depends on the programming in the control:
•
Activation by pressing the start button halfway down (4.2.3 Start button, Page 12).
• Time-controlled beginning at start
• You also have the option of disabling it.
The range of the LED illumination is 500 mm.
4.2.8 Power supply
See instruction manual for battery pack/instruction manual for power module PM48
If the data transmission has been interrupted, the LCD display reports a synch error.

Replace the tool in the tool holder.
The complete data transmission is acknowledged on the display with Rest 512 .