Cleco 17BP, Инструкция по эксплуатации

Страница: 21 / 64

2291c-enu_LCD_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 21
LCD display
8
8 LCD display
The LCD display on the tool is divided into the result display, status display, operating menu and system
error messages.
8.1 Result display
First line – result:
The status is displayed in alternation with the Application being used.
The LCD display consists of a three lines, each with 6 characters,
to display the status, torque and angle. The result display is updated after the rundown
ends.
OK Result is OK
NOK Result is not OK
OFF Torque encoder offset error
CAL Torque encoder calibration error
ENC Angle encoder error
IP Current overload in output section
IIT Requested motor output is too high
TMAX Maximum fastening time exceeded
RC Rundown terminated by disabled start signal
TS Depth sensor signal was enabled at start or
was subsequently disabled during the rundown (only for 17BP series)
Tq< Torque too low
Tq> Torque too high
WI< Angle too small
WI> Angle too large
Error Error occurred
AW< Too few graphic values recorded for an evaluation (SEQ 31/51)
BLOC Fastened to block / tightened screw fastened (SEQ 31/51)
IRED Current redundancy error
JMP Bit jump detected
MBO> Torque has exceeded top evaluation torque (SEQ 31/51)
MBU< Torque has fallen below bottom evaluation torque (SEQ 31/51)
MDSI Safety torque exceeded (SEQ 31/51)
SS> Time for stick-slip too large
SST Too many stick-slip edges
TTT< Time since TT too small
TTT> Time since TT too large
Second line – Shut-off torque in Nm:
T Shutoff torque
Third line – Shut-off angle in degrees:
A Shutoff angle
OK
T12.00
A100