Cleco 17BP, Инструкция по эксплуатации

Страница: 36 / 64

36 P1890E/EN 2017-06
2291c-enu_LCD_bedingt.fm, 25.08.2017
LCD display
8
The current setpoint has been exceeded.
There may be a short circuit.
 Return tool to Sales & Service Centers for repair.
The servo has overheated.
 Switch the tool off for a time so that it can cool down.
 Increase the cycle time, reduce the fastening time or the torque.
The tool motor has overheated.
 Switch the tool off for a time so that the motor can cool down.
 Increase the cycle time, reduce the fastening time or the torque.
Operating voltage is outside the admissible range.
 Change the battery. If this does not help:
 Return tool to Sales & Service Centers for repair.
Current at servo output stage is too high.
There may be a short circuit.

Return tool to Sales & Service Centers for repair.
Tool angle encoder is sending incorrect signals to the servo amplifier.
 Return tool to Sales & Service Centers for repair.
Warns that battery is running low.
 Recharge battery or replace it with one that is already charged.
Servo firmware is not compatible with measuring board software.
 Update servo firmware.
The rundown counter could not be read or written to.
 Return tool to Sales & Service Centers for repair.
Tool memory could not be read.
 Return tool to Sales & Service Centers for repair.
Servo
Error
IP
Servo
Error
Temp >
Servo
Error
TempM>
Servo
Error
Voltag
Servo
Error
Curr>
Servo
Error
Angle
Low
voltag
warnin
Servo
Error
Othe80
Tool
Error
Counte
Tool
Error
Ident