Cleco 17BP, Инструкция по эксплуатации

Страница: 37 / 64

2291c-enu_LCD_bedingt.fm, 25.08.2017
P1890E/EN 2017-06 37
LCD display
8
Two-stage start button defective.
 Return tool to Sales & Service Centers for repair.
Transducer reference voltage error
 Return tool to Sales & Service Centers for repair.
Transducer calibration voltage error
Tool was not discharged at time of calibration.

Allow tool to discharge and try again. If this does not help:
 Return tool to Sales & Service Centers for repair.
Transducer offset voltage error
Tool was not discharged at time of calibration.
 Allow tool to discharge and try again. If this does not help:
 Return tool to Sales & Service Centers for repair.
General collective error
Return tool to
Sales & Service Centers for repair.
The battery is empty.
 Replace the battery.
The min. torque for evaluation was not reached.

Repeat the current rundown.
Initialization error LiveWire Memory Chip .

Switch the tool on and off again.
 Check the parameters in the software controller.
 Insert the WLAN chip again. Replace if necessary.
 Return tool to manufacturer for repair.
WLAN module programming initialization fault.
 Switch the tool on and off again.
 Check the parameters in the software controller.

Return tool to manufacturer for repair.
Tool
Error
Start
Transd
Ref.V.
Error
Trans
CAL
Error
Trans
Off
Error
Unknow
Error
Batter
empty
-> off
No
result
LMC
Error
WLAN
error