Cisco Nexus 7004, Руководство по установке и справочное руководство по оборудованию

Страница: 274 / 508

10-16
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Replacing a Supervisor Module
Caution
Make sure that you do not accidentally press one or more of the ejector release buttons on the I/O,
supervisor, and fabric modules. These buttons and their mechanical levers are designed so that you can
easily power down and remove these modules when you need to replace them. If you press one of these
buttons, the lever for that button releases from the front of the module, but the module remains
operational and connected to the system. If you press the other ejector button on the same module at the
same time as you press the first button or while the lever for the first button is released, the lever for the
second button releases, and the module powers down and disconnects from the system.
To minimize the chance of accidentally disconnecting a module with a released lever, press the lever
back toward the module until it clicks. If both levers are released, the system has disconnected and
powered down the module, and the STATUS LED will be unlit. To reconnect and power up the module,
either remove and reinsert the module in the chassis or use system commands to power it on.
This section describes how to replace supervisor modules and includes the following topics:
• Required Tools, page 10-16
•
Replacing a Redundant Supervisor Module During System Operations, page 10-16
• Replacing a Supervisor Module in a Single-Supervisor System, page 10-21
•
Replacing Supervisor 1 Modules with Supervisor 2 or Supervisor 2E Modules, page 10-23
• Replacing Supervisor 2 Modules with Supervisor 2E Modules, page 10-27
•
Upgrading Memory for Supervisor 1 Modules, page 10-29
Required Tools
You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the captive screws on
the supervisor module.
Replacing a Redundant Supervisor Module During System Operations
During operations, one supervisor is active while the other (redundant) supervisor is in standby mode.
You can replace either of these two supervisors. If you need to replace the active supervisor, it becomes
the standby supervisor as soon as you press its ejector buttons.
Note
A replacement supervisor module comes with one DIMM (4 GB of memory) or, if your switch is running
Cisco NX-OS 5.1 (or later release), two DIMMs (8 GB of memory). If the switch not running a version
of Cisco NX-OS that is compatible with using 8 GB of memory, then you must use only one DIMM (do
not install an additional DIMM).
Caution
If you cannot immediately replace a supervisor, either leave the supervisor in its slot until it can be
replaced or replace it with a blank module so the system airflow is not disrupted. If the system airflow
is disrupted for more than a couple of minutes, the system could overheat and shut down.