Canon iR3570 Series, Руководство по обслуживанию

Страница: 90 / 722

Chapter 2
2-16
machine to the 2-level cassette pedestal Y2 or more.)
F-2-71
- Shut-Down Warning Label
1) Attach the Shut-Down warning label [1] of the appropriate language to the
right cover (rear) of the machine (i.e.,. on the left inside [2] of the main
power supply.).
F-2-72
- Toner Bottle Warning Label
1) Open the front cover [1].
F-2-73
2) Attach the Toner Bottle warning label [1] of the appropriate language
behind [2] the front cover.
F-2-74
- Ferrite Core (230V model only)
1) Fit the ferrite core [1] to the network cable [2].
Be sure to fit the ferrite core as follows to protect against noise:
- Be sure to fit it as close to the joint between the machine and the network
cable as possible.
- The harness must be wound around the ferrite core once before the core is
fixed in place.
- The harness is not trapped by the ferrite core.
F-2-75
When installing the machine newly or when replacing the harness, be
sure not to leave behind the ferrite core.
2.2.13 If Not Connected to a Network
0007-6496
iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
Reference
If the machine is not connected to a network, its control panel will indicate
the message "Check the Connection to the Network." To disable the mes-
sage, turn off the following user mode item:
system setup>network>Ethernet driver setup>auto detect
2.3 Checking the Connection to the Network
2.3.1 Overview
0007-5605
iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
The instructions that follow apply only when the machine is connected to a
network.
If the user's network environment is based on TCP/IP, use the PING function
to make sure that the network settings are correct.
If the user's network environment is based on IPX/SPX or AppleTalk, on the
other hand, such a check need not be made.
2.3.2 Using the PING Function
0007-5600
iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
1) Make the following selections in service mode:
COPIER>TEST>NETWORK>PING.
2) Enter the correct IP address using the control panel keypad, and press the
OK key.
3) Press the Start key.
- If successful, the indication will be 'OK'. If the attempt fails, however, 'NG'
will be indicated.
F-2-76
[1] Result (OK/NG)
[2] IP address input
2.3.3 Making a Check Using a Remote Host Address
0007-5603
iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
You can use a remote host address in combination with the PING function to
check the connection to the network.
[2]
[1]
[2]
[1]
[2]
[1]
0. 0. 0. 0
+/- OK
<NETWORK> < 1/1 > <READY >
PING
[2]
[1]