Canon iR3570 Series, Руководство по обслуживанию

Страница: 620 / 722

Chapter 15
15-32
E514 0001
Stack delivery motor
error (Finisher-S1)
When the stack retainer
is moving to home
position, the return belt
escape HP sensor does
not go on within 1.5
sec. Replace the finisher controller
PCB. Replace the stack delivery
motor. Check the stack delivery
drive mechanism.
0002 When the stack retainer
is moving from home
position, the return belt
escape HP sensor does
not go off within 1.5
sec.
E520 0001 The offset motor or the
finisher controller PCB
is faulty. The offset
home position sensor is
faulty. While the offset motor
is in operation, drive
was applied for 1000
msec for movement
toward the home
position sensor;
however, the offset
home position sensor
does not go on. Replace the offset motor. Replace
the offset home position sensor.
Replace the finisher controller
PCB.
0002 While the offset motor
is in operation, drive
was applied for 1000
msec for movement
away from the home
position sensor;
however, the offset
home position sensor
does not go off.
E530 8001
Rear alignment error
(Finisher-S1)
When the rear aligning
plate is moving to home
position, the HP sensor
is not identified as
being ON within 2000
msec after the start of
the movement. Replace the finisher controller
PCB. Replace the rear alignment
motor. Check the rear aligning plate
drive unit. Check the rear alignment
HP sensor.
8002 When the rear aligning
plate is moving from
home position, the HP
sensor is not identified
as being OFF within
1000 msec after the
start of the movement.
E531 8001
Staple error (Finisher-
S1)
At time of a staple jam
recovery session, the
HP sensor is not
identified as being ON
within 500 msec after
the start of staple motor
reversal drive. Replace the finisher controller
PCB. Replace the Staple. Check the
harness.
8002 The HP sensor is not
identified as being OFF
within 500 msec after
the start of staple motor
drive.
E532 8001
Stapler shift error
(Finisher-S1)
When the stapler is
moving to home
position, the stapler
slide HP sensor does
not go on within 11 sec. Replace the finisher controller
PCB. Replace the stapler shift
motor. Check the stapler shift home
position sensor. Check the harness.
8002 When the stapler is
moving from home
position, the stapler
slide HP sensor does
not go off within 1.0
sec.
E535 0001
Swing cam error
(Finisher-S1)
When the swing arm is
moving from home
position, the HP sensor
is not identified as
being OFF within 1000
msec after the start of
the movement. Replace the finisher controller
PCB. Replace the swing cam motor.
Check the swing cam home position
sensor. Check the harness.
0002 When the stack delivery
roller swing arm is
moving from home
position, the swing cam
HP sensor does not go
off within 1.0 sec.
Code Detail code Items Description Remedial action