Canon imagePASS-P2, Руководство по обслуживанию

Страница: 37 / 92

2. Position the new service board inside the chassis, fitting the LED display and service switches through the cutouts in the
chassis.
3. Secure the service board to the chassis using the two screws that you removed earlier (see above figure)
4. Connect the service board cable to the connector on the service board.
The cable is keyed to fit in the connector only one way.
5. Connect the free end of the service board cable to connector Port 80 Header (EFI GPIO Header, J4) on the motherboard.
The cable is keyed to fit in the connector only one way.
6. Make sure that the service switches are set to the OFF position (both switches are away from ON). See “imagePASS
connector panel and LED diagnostic codes” on page 14 .
7. Reassemble the imagePASS and verify its functionality (see “To reinstall and verify the imagePASS” on page 38 ).
■ Chassis fan
One chassis fan is installed in the imagePASS, near the service board. Use the following procedures to remove or replace the
fan.
● To remove the chassis fan
1. Access and open the imagePASS, as described on “Accessing the imagePASS” on page 16 .
2. Disconnect the 4-pin fan cable connector from the motherboard.
3. Remove the four plastic rivets that attach the fan to the chassis, and remove the fan.
To remove a rivet, use a flathead screwdriver to pry loose the rivet head on the outside of the chassis while squeezing and
pushing the locked end of the rivet with your fingers or a pair of pliers. Set the rivets aside so that you can replace them later.
1
2
Figure 22: Removing the chassis fan
No. Item
1 Rivet (1 of 4)
2 Chassis fan
4. If you are removing the chassis fan in order to replace it with a new one, remove the fan guard from the face of the fan (see
below figure).
To remove the plastic rivets that secure the fan guard to the fan, use a flathead screwdriver to pry loose the rivet head while
squeezing and pushing the locking end of the rivet with your fingers or a pair of pliers.
Set aside the fan guard and rivets so that you can install them later on the new chassis fan.
3. REPLACING PARTS
32