Campbell CR850, Руководство оператора

Страница: 294 / 566

Section 8. Operation
294
Other sensors, e.g., LVDTs (linear variable differential transformers), require an
ac excitation because they rely on inductive coupling to provide a signal. dc
excitation will provide no output.
CR800 bridge measurements can reverse excitation polarity to provide ac
excitation and avoid ion polarization.
Note Sensors requiring ac excitation require techniques to minimize or eliminate
ground loops. See Ground Looping in Ionic Measurements
(p. 91).
8.1.3.2 Accuracy of Ratiometric-Resistance Measurements
The ratiometric-accuracy specification for resistance measurements is:
±(0.04% * V1 + Offset ), ‐ 25° to 50° C,
where V1 is the voltage measurement and Offset is equal to one of the
following, where the Basic Resolution is the resolution of a single A/D
(p.
425
)
conversion. Note that excitation reversal reduces offsets by a factor
of two:
•
Offset = 1.5 x Basic Reso 1.0 µV if the measurement is made on a
differential input channel with input reversal
•
Offset = 3 x Basic Reso 2.0 µV if the measurement is made on a
differential input channel without input reversal
•
Offset = 3 x Basic Reso 3.0 µV if the measurement is of a single-
ended input channel
•
The following table lists basic resolution values.
Table 62. Analog Input-Voltage Range and Basic
Resolution
Range (mV) Basic Resolution (µV)
±
5000
±
2500
±
250
±
25
±
7.5
±
2.5
1333
667
66.7
6.7
2.0
0.67
Assumptions that support the ratiometric-accuracy specification include:
•
Excitation voltages less than 1000 mV are reversed during the excitation
phase of the measurement.