Cagiva Navigator, Руководство по ремонту

Страница: 372 / 407

G.35
ELECTRICAL EQUIPMENT
+ -
HEADLIGHT BEAM ADJUSTMENT
Periodically check the headlight beam for adjustment. Carry out the
adjustment as follows:
• Place the machine 10 metres from a vertical wall.
• Ensure that the ground is level and that the headlight beam axis is
perpendicular to the wall.
• The machine must be in a vertical position with the rider on board.
• Measure the height X of the centre of the beam from the ground.
• Mark a cross on the wall, at a height of 9/10ths of the X height;
• Switch on the main beam. The upper limit of the illuminated zone
must be at a height not less than the cross marked on the wall
previously (9/10ths of X).
Any adjustment necessary can be made by regulating the adjuster
screw 2 on the back of the projector body.
This is done as follows:
• Remove the windshield, the nose fairing and the instrument panel
as described in Chapter B.
• Make the adjustment using a screwdriver. Screwing in the adjuster,
the band of light rises; unscrewing the adjuster, lowers the band of
light.
1
2
To substitute the rear light bulb, it is necessary to remove the two
screws 1, by gaining access from the inside of the number plate
holder.
Remove the lens from the outside and remove the bulb from its
holder.
Substitute the blown bulb and reassemble.