Brother BE-100, Рабочая тетрадь

Страница: 114 / 119

111
■
Needle breaks
■
Skipped stitches
■
Puckering
Cause Action
Improper timing
If the needle and hook point are not timed properly, damage to both could result.
Also stitching quality suffers. Replace damaged parts and re-time machine.
Needle inserted incorrectly
Follow your machine manual’s instructions for inserting the needle. Make sure
that it is all the way up into the needle bar shaft, it is rotated properly, and the
needle screw is tight.
Bent needle Always replace a needle if it hits, or even grazes, a hoop or other hard object.
Dull needle
Dull needles with bow in an effort to push through the fabric and eventually
break.
Holding loose end of
thread during start-up
Pulling the thread too tight and either wrapping it around the holding disk or
holding it in your hand causes the needle to bend, and the needle and/or thread
to break.
Cause Action
Wrong needle size
Needles are too small or large in relation to the thread size and make it difficult
for loops to form.
Too tight or too loose twist
on thread Improper twist results in irregular loop formation. Try a new cone or different
color to test this possible cause.
Incorrect timing The bobbin hook is not catching the loop. Reset timing.
Cause Action
Tight tensions
Adjust tensions for specific garment and thread. For example, polyester thread
will stretch during sewing, especially if tensions are too tight. After the stitching
is complete, the thread returns to its original strength, puckering the garment.
Improper hooping tension
Hoop sturdy, woven fabrics tightly; loose hooping will cause the fabric to bunch
up under the stitching. Hoop soft knits tautly, using a stable backing; over-
stretching the garment will cause it to look puckered when removed from the
hoop.
Unstable fabric
Use a backing, and be sure to hoop it with the garment. For added stability, use
an adhesive spray designed for embroidery to affix backing to garment or use
an iron-on tearaway backing.
Column stitches are too
long
Re-punch as fill stitching or multiple rows of column stitching.
Dull needles
Dull needles push fabric down instead of pushing between or piercing the
weave. Replace needles.
Design densities are too
heavy
Too many stitches in an area pull the fabric causing it to look puckered.
Decrease density, increase the design slightly (5% to 10%) or use a thinner
thread.