![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319077.webp)
ImagePRO-II • User’s Guide
63
4. Menu Orientation
Working with Test Patterns
~
H Offset
— Sets the horizontal offsets, in increments of +/- one-half
line
,
in pixels. The range depends on the output format.
~
V Offset
— Sets the vertical offsets, in increments of +/- one-half
frame
.
The range depends on the output format.
•
Status
— The current status.
p~îáåÖ=~å=lìíéìí=`çåÑáÖìê~íáçå=
To save the custom output configuration of the selected output, select
Save Config
from
the
Output Menu
. The settings are saved in non-volatile memory, and the save persists
across power cycles.
oÉëíçêáåÖ=lìíéìí=`çåÑáÖìê~íáçå=aÉÑ~ìäí=s~äìÉë
To remove user-defined configuration settings and restore the default values for the current
output, select
Reset Config
from the
Output Menu
. If you select this command, custom
configurations are not restored the next time you power up the ImagePRO-II.
tçêâáåÖ=ïáíÜ=qÉëí=m~ííÉêåë
As you configure outputs, you can set up test patterns. You can send one test pattern to all
outputs simultaneously.
Test patterns appear within the output’s Area of Interest (AOI). If the output image uses the
default AOI, the test pattern is displayed in the default active area. If you set up a custom
AOI for the output, the test pattern appears within that AOI. For more information, refer to
the
Setting the Area of Interest
on page 52.
You can also set up raster boxes for both the AOI and the output active area.
pÉííáåÖ=ré=~=qÉëí=m~ííÉêå
To set up a test pattern on an output, use the following procedure:
1.
Press the
TEST PAT
button. The
Test Pattern Menu
appears, as shown in the
following illustration.
Figure 4-43.
Test Pattern Menu
Note
Output settings revert to the last
saved
state when you power
up the ImagePRO-II. If you do not save your settings, they
are not restored.
TEST
PAT
TEST PATTERN
> Type
Off
Raster Box
Off
Diag Motion
Off
AOI Raster Box
Off
Содержание ImagePRO-II
