![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319100.webp)
86
ImagePRO-II • User’s Guide
4. Menu Orientation
Using the System Menu
pÉííáåÖ=ré=Ñçê=íÜÉ=båÅçêÉ=çê=pÅêÉÉåmolJff=`çåíêçääÉê
The
Barco Remote Control Submenu
sets up the ImagePRO-II for remote control
through a Barco Encore or ScreenPRO-II Controller.
Figure 4-75.
Barco Remote Control Submenu (sample)
To connect an ImagePRO-II to an Encore or ScreenPRO-II Controller, use the
following procedure:
1.
On the
Ethernet Submenu
, enable DHCP mode and obtain an IP address for the
Encore Controller.
2.
On the
Ethernet Submenu
, select
Remote Control
. The
Barco Remote Control
Submenu
appears, as shown in the preceding illustration.
3.
The
Unit ID
defaults to
18
. To change this setting, select
Unit ID
and scroll to
another number. Select an ID that is not being used by other devices.
4.
In the
IP
field, scroll through the four fields to enter the IP address of the
appropriate controller. When you select IP, the last character in the first field
becomes available. Turn the
ADJUST
knob to change the value.
As you continue turning the knob, you can change all three values in this field.
Values range from
000
to
255
in all four fields.
5.
Press
SEL
to accept your change in the first field. The last character in the next
field becomes available.
6.
Continue until you have entered the IP address you want. Press
SEL
again.
7.
In the
Connect
field, select
On
. The following message appears:
Figure 4-76.
Remote Connection Message
8.
When the connection is established, a confirmation message appears.
BARCO REMOTE CONTROL
> Unit ID
18
IP
192.168.000.001
Status
n/a
Connect
Off
Save Config
Note
The default IP address of the
Encore Controller
is
192.168.0.1
.
The default IP address of the
ScreenPRO-II Controller
is
192.168.0.2
.
Attempting remote
connection
Please wait . . . .
Содержание ImagePRO-II
