![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319027.webp)
ImagePRO-II • User’s Guide
13
2. Hardware Orientation
ImagePRO-II Rear Panel
2) Ethernet
Port
One RJ-45 connector is provided for
10/100BaseT
Ethernet
communications
with the ImagePRO-II. The port is used for running the Web Interface, for
diagnostics, and for connection to an external device such as the
Encore
or
ScreenPRO-II Controller
.
The Ethernet connector is compatible with:
~
Standard RJ-45 Ethernet cables
~
Neutrik EtherCon
®
series cables
For pinout details, refer to the
Standard Connector Pinouts
section in
Appendix A, on page 136.
fåéìí=sáÇÉç=`çååÉÅíçêë
On the system’s rear panel, each of the input connectors maps to a corresponding input
button on the front panel. For additional information about any connector, including pinouts
and a list of supported formats, refer to
Appendix A,
Specifications
, on page 131.
3) Input
1
— DVI-I Input with Loop-through
4) Input
2
— Analog Input with Loop-through
5) Input
3
— HDMI Input
6) Input
4
— DisplayPort Input
7) Input
5
— SDI-1 Input with Loop-through
lìíéìí=sáÇÉç=`çååÉÅíçêë
The user sets the output format. Output connectors are active only if they support the
selected format. If a connector cannot support the selected format, that connector is
deactivated. Therefore, all connectors may not be active at the same time.
The default output format is 1024x768 @ 59.94. You can select other formats for an output,
or define custom formats. Outputs revert to the last
saved
state on power-up.
Output colorspace is adjustable for the HD-15, DVI, HDMI, and DisplayPort connectors.
For additional information about any connector, including pinouts and a list of supported
formats for each connector, refer to
Appendix A,
Specifications
, on page 131.
8) SDI-1
Output
9) Composite
Video
Output
10) DVI-D Output
11) Universal Analog Output
12) HDMI Output
13) DisplayPort Output
dÉåäçÅâ=fåéìí=`çååÉÅíçê
14) Genlock Input BNC with passive Loop-through
The Genlock input supports NTSC and PAL Blackburst, as well as HD tri-level
sync signals, per SMPTE 274M and SMPTE 296M. The passive loop-through can
be used to pass the Genlock signal to another device downstream of the
Содержание ImagePRO-II
