![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319103.webp)
ImagePRO-II • User’s Guide
89
4. Menu Orientation
Using a Logo or Internal Black
p~îáåÖ=póëíÉã=pí~íÉ
Save System State
on the
System Menu
saves your custom configuration parameters in
non-volatile memory, including:
•
The currently selected input channel
•
The output configuration
•
System settings such as Black Invalid, HDCP settings, Input EDID information,
and display brightness
If you save the system state, these parameters are restored the next time you power up the
ImagePRO-II. If you
do not
use this function, your custom settings are not restored during
the next system power up sequence.
rëáåÖ=~=içÖç=çê=fåíÉêå~ä=_ä~Åâ
The ImagePRO-II supports capturing and storing one full-screen image called a
logo
,
which can be displayed during transitions. Typically, the logo is a corporate logo, but it can
be any still image captured from an ImagePRO-II, up to a maximum resolution of
2560x1600
. You can capture the logo from the active video input, or upload an image using
the ImagePRO-II’s USB port or the Web Interface. The logo appears on top of all other
sources when you transition to it.
You cannot scale the logo.
If the logo is of higher resolution than the current output format,
the image appears cropped. If the logo is of lower resolution than the current output format,
the entire logo appears in the center of the output display. For examples, refer to
Displaying a Logo
on page 91 of this chapter.
You can also set up an input to transition to internal black instead of a logo. For information
about transitioning to and from a logo or black, refer to
Setting Transitions
on page 76 of
this chapter.
The ImagePRO-II provides the following ways to work with logos and internal black:
•
The
LOGO
and
BLACK
buttons on the front panel
•
The
Logo Menu
This section discusses both methods of capturing, deleting, and restoring a logo or internal
black.
In addition to these methods, you can also downloading or restore a logo from a USB flash
drive or from the ImagePRO-II Web Interface. For details, refer to
Using a USB Device
on
page 80 of this chapter, or
Backing Up and Restoring Data with the Web Interface
, on
page 102 of Chapter 5.
Please note the following important points regarding the logo:
•
After you save a logo, the image remains in memory across power cycles.
•
You can de-select the logo on display by pressing one of the input buttons or
BLACK
.
•
When the
LOGO
or
BLACK
button is selected, the
PAN/ZOOM
button is not
operational.
Note
To save the configurations of all inputs, refer to
Setting up an
LED Wall
on page 94 of this chapter
Содержание ImagePRO-II
