![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319072.webp)
58
ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
~
YCbCr, 4:4:4, 36 bit
The default setting upon format change is:
~
RGB, 4:4:4, at a bit depth equal to the maximum supported, as given in
the EDID information.
The default setting when the EDID information is invalid or not present is:
~
RGB, 4:4:4, 24 bits
•
DisplayPort
— The options are:
~
RGB, 4:4:4, 24 bit
~
RGB, 4:4:4, 30 bit
~
RGB, 4:4:4, 36 bit
~
YCbCr, 4:4:4, 24 bit
~
YCbCr, 4:4:4, 30 bit
~
YCbCr, 4:4:4, 36 bit
The default setting upon format change is:
~
RGB, 4:4:4, to the maximum bit depth supported, as given in the EDID
information
The default setting if EDID information is invalid or not present is:
~
RGB, 4:4:4, 24 bit
The 36-bit rates may not be available if output timings are not compatible.
pÉííáåÖ=lìíéìí=bÑÑÉÅíë
The
Output Effects Submenu
sets properties of the output image, such as contrast and
brightness, color balance, and sharpness. From the
Output Menu
, select
Effects
to
access this menu.
Figure 4-35.
Output Effects Submenu
Note
For the
SDI
output, there is only one setting — YCbCr, 4:2:2,
20 bit — and it cannot be changed.
OUT EFFECTS
> Contrast
100
Brightness
100
Color Balance
>>
Gamma
1.0
Monochrome
Off
Invert
Off
Sharpness
+0
Flicker Reduce
n/a
Image Flip
Off
Strobe Mode
Off
Strobe Rate
n/a
Содержание ImagePRO-II
