![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319133.webp)
ImagePRO-II • User’s Guide
119
5. Web Remote Control Operations
Configuring Inputs with the Web App Interface
3.
Select
H Pos
to pan an image left or right, within the active area. Values are in
pixels. The default value is
0
, representing the horizontal center of the active area.
Decreasing the
H Pos
value moves the image to the right. Increasing the
H Pos
value moves the image to the left.
4.
Select
V Pos
to pan an image up or down, within the active area. Values are in
lines. The default value is
0
, representing the vertical center of the active area.
Decreasing the
V Pos
value moves the image up. Increasing the
V Pos
value
moves the image down.
j~ëâáåÖ=~å=fã~ÖÉ=ïáíÜ=íÜÉ=tÉÄ=^éé=fåíÉêÑ~ÅÉ
In the
Mask
section of the
Input
Sizing Adjust
page, you can mask each edge separately.
Masking an image means applying black bars to one or more edges, typically to remove
noise. Mask values are given in percentages, and range from
0%
to
100%
. The default
mask value is
0%
.
To mask the image on display, change the values for one or more edges, either by
moving the slider to the right from
0
, or by typing a percentage value in the field to the
left of the slider.
If you wish to mask all the edges at once to achieve a particular aspect ratio, you can do so
from the front panel. Refer to the
Using Mask Presets
section of Chapter 4, on page 39.
p~îáåÖ=~åÇ=oÉëÉííáåÖ=fåéìí=`çåÑáÖìê~íáçåë
After changing an input’s settings, you can save those settings on the
Input Config
page.
On this page, you can also restore the input’s default configuration after making changes.
Figure 5-21.
The Input Config Page
To save an input’s custom configuration settings, use the following procedure:
1.
With the input selected, navigate to
Input
>
Input Config
.
2.
Click the
filename
field beside the
Save Config
button. Type a filename.
The filename can consist of up to 20 alphanumeric characters. If you include
spaces or special characters — such as asterisks, percentage signs or
ampersands — the field background turns red and you cannot save the name.
3.
Click
Save Config
. A confirmation message appears.
To restore the input to its default configuration, select the input and click
Reset Config
.
Содержание ImagePRO-II
