![background image](http://html1.mh-extra.com/html/barco/imagepro-ii/imagepro-ii_user-manual_3868319137.webp)
ImagePRO-II • User’s Guide
123
5. Web Remote Control Operations
Configuring Outputs with the Web App Interface
Figure 5-25.
Area of Interest Page
To change the Area of Interest, use any of the following settings:
•
H Size
— Determines the width (in pixels) of the Area of Interest. This setting
must be equal to or less than the
H Active
setting of the output timing.
•
V Size
— Determines the height (in lines) of the Area of Interest. This setting must
be equal to or less than the
V Active
setting of the output timing.
•
H Pos
— If
H Size
is less than the
H Active
setting of the output timing, you can
move the image horizontally. The default setting of
0
represents the
left
of the
display, so increasing this value moves the Area of Interest to the
right
.
•
V Pos
— After adjusting the
V Size
, you can move the image vertically within the
output’s active vertical limits. The default setting of
0
represents the
top
of the
display, so increasing this value moves the Area of Interest
down
.
lÄí~áåáåÖ=lìíéìí=bafa=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
Extended Display Identification Data
(
EDID
) is a data structure that an output display
uses to describe itself to a video source. The EDID can include information such as the
manufacturer’s name, a serial number, product type, timings supported by the display,
display size, and other data.
For output devices connected to the
ImagePRO-II
, you can read the name of the digital
display and the preferred video format that the display uses.
The
EDID Config
page, shown in the following illustration, supports
letting the output
device on the
DVI-D
,
HD-15
,
HDMI
, or
DisplayPort
connector change the output format of
the ImagePRO-II
.
As the format changes, the colorspace, sample rate and bit depth may
also change.
Содержание ImagePRO-II
