DME Setup Manual
1
DME Setup Manual
This manual describes the process of setting up a DME system, from making the initial DME processor settings
(DME64N / DME24N / DME8i-C / DME8o-C / DME4io-C / DME8i-ES / DME8o-ES / DME4io-ES) to synchronizing with
the DME Designer application installed on a computer.
n
For details about the DME units refer to the manual supplied with the specific device, and for details about the DME Designer
application refer to the pdf-format DME Designer manual.
n
In this document the term “DME” will refer to the DME64N, DME24N, DME8i-C, DME8o-C, DME4io-C, DME8i-ES, DME8o-ES and
DME4io-ES, while the term “DME Satellite” will refer only to the DME8i-C, DME8o-C, DME4io-C, DME8i-ES, DME8o-ES and DME4io-ES.
Workflow
Software Installation
●
DME Designer and DME-N Network Driver installation (
).
●
USB-MIDI Driver installation (
DME Network Setup (page 6)
Connecting via a USB cable and setting the DME IP address and Device Group Master/Slave status from the
DME Designer.
Computer to DME Connection (page 8)
The procedures for connecting a single DME unit to a computer as well as for connecting multiple DME units to a
computer in the same subnet are described. Refer to the DME manual for information on audio connection and
further network connection details.
Computer Network Setup
These settings must be made properly when connecting a computer to DME units via an Ethernet cable.
●
Computer TCP/IP settings (
●
DME-N Network Driver settings (
).
DME Designer Operation
●
Creating Configurations (
).
Explains the process of launching the DME Designer application and combining and connecting various
audio components to create configurations.
●
Explains how to go online and transfer configurations created using the DME Designer application to DME
devices.
Troubleshooting (page 17)
Appendix
●
DME64N/24N Network Setup via Panel Operation (
).
●
DME-N Network Driver Setup Details (
).
