Technical data • Individual components
Chapter 2
Technical data
Panel PC 800 User's Manual V1.30
131
Product ID
5ACPCI.RAIC-03
Weight
350 g
Manufacturer information
Manufacturer
Fujitsu
Manufacturer's product ID
M120-ESW MHY2160BH-ESW
Table 103: 5ACPCI.RAIC-03 - Technical data
1)
Temperature values at an elevation of 305 meters. The temperature specification must be reduced linearly by 1°C every 305 meters. The temperature
increase and decrease can be a maximum of 3°C per minute.
2)
Standard operation refers to 333 POH (power-on hours) per month.
3)
24-hour operation refers to 732 POH (power-on hours) per month.
4)
Maximum humidity at 29°C.
5)
Maximum humidity at 40°C.
6)
Operation in areas prone to vibration and shock can affect performance negatively (reduction of transfer rate).
7)
Installed in PCI slot.
3.9.20.4 Temperature humidity diagram
Temperature [°C]
R
el
at
iv
e
hu
m
id
ity
[%
R
H
] (
no
n-
co
nd
en
si
ng
)
Operation
St
or
ag
e
/ T
ra
ns
po
rt
Figure 55: 5ACPCI.RAIC-03 - Temperature humidity diagram
3.9.20.5 Driver support
Special drivers are necessary for operating the PCI SATA RAID controller. Drivers for supported and approved
operating systems are available in the Downloads section of the B&R website (
.NET-based SATA Raid™ serial ATA RAID management software can also be found on the B&R website.
Information:
Required drivers can only be downloaded from the B&R website, not from manufacturer websites.
3.9.20.6 Configuration
For information about configuring a SATA RAID set, see 3 "Installation", section 8 "Configuring a SATA RAID set"
3.9.20.7 Replacing a HDD
A hard drive can be easily replaced in the event of an error when using the RAID1 (mirroring) configuration without
having to reinstall the system. The 160 GB 5ACPCI.RAIC-04 SATA HDD is available as a replacement hard disk.
For instructions on replacing the drive, see 7 "Maintenance and service", section 14 "Replacing a PCI SATA RAID