Installation • Configuring a SATA RAID set
Chapter 3 Installation
Panel PC 800 User's Manual V1.30
179
8.5 Rebuild mirrored set
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2006
Create RAID set
Delete RAID set Rebuild help
Resolve conflicts
Low level format
0 PM
1 SM
0 ST96023AS
Select Menu
1
ESC Previous Menu
Enter Select
Ctrl-E Exit
* First HDD
ST96023AS 55GB
ST96023AS 55GB
* Set0 SiI Mirrored Set <PM> 55GB
Current
ST96023AS rebuild
Rebuild Mirrored set
online rebuild
offline rebuild
Figure 89: RAID Configuration Utility - Rebuild mirrored set
The "Rebuild mirrored set" menu option can be used to restart a rebuild procedure in a RAID 1 set if an error
occurs, if a rebuild procedure was interrupted or if a hard disk was replaced.
If "Online rebuild" is selected, then the rebuild is executed during operation after the system is booted. The installed
SATA RAID configuration program may display an event pop-up message:
SATA Raid detected a new event
before restarting the rebuild. The entire rebuild takes approximately 50 minutes.
If "Offline rebuild" is selected, then a rebuild is performed immediately before the operating system is started
(duration depends on the respective memory size).
8.6 Resolve conflicts
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2006
Create RAID set
Delete RAID set Help for resolving
Rebuild Mirrored set conflicts
Low level format
0 PM
1 SM
0 ST96023AS
Select Menu
1
ESC Previous Menu
Enter Select
Ctrl-E Exit
* First HDD
ST96023AS 55GB
ST96023AS 55GB
* Set0 SiI Mirrored Set <PM> 55GB
Current
ST96023AS Current
Resolve conflicts
Figure 90: RAID Configuration Utility - Resolve conflicts
Conflicts in a RAID set can be resolved using the "Resolve conflicts" menu option. This function is only available
if the status of the hard disk is "Conflict".