Technical data • Individual components
Chapter 2
Technical data
Panel PC 800 User's Manual V1.30
139
Product ID
5ACPCI.RAIC-06
Weight
350 g
Manufacturer information
Manufacturer
Western Digital
Manufacturer's product ID
WD5000LUCT
Table 109: 5ACPCI.RAIC-06 - Technical data
1)
Yes, although applies only if all components installed within the complete system have this certification
2)
Technical data for a hard disk.
3)
With 8760 POH (power-on hours) per year and 25°C surface temperature.
4)
Temperature values at an elevation of 305 meters. The temperature specification must be reduced linearly by 1°C every 305 meters. The temperature
increase and decrease can be a maximum of 20°C per hour.
5)
Standard operation refers to 333 POH (power-on hours) per month.
6)
24-hour operation refers to 732 POH (power-on hours) per month.
7)
Humidity gradient: Maximum 20% per hour.
8)
Operation in areas prone to vibration and shock can affect performance negatively (reduction of transfer rate).
9)
Installed in PCI slot.
3.9.23.4 Temperature humidity diagram
Temperature [°C]
R
el
at
iv
e
hu
m
id
ity
[%
R
H
] (
no
n-
co
nd
en
si
ng
)
Operation
Storage
Transport
Figure 60: 5ACPCI.RAIC-06 - Temperature humidity diagram
3.9.23.5 Driver support
Special drivers are necessary for operating the PCI SATA RAID controller. Drivers for supported and approved
operating systems are available in the Downloads section of the B&R website (
.NET-based SATA Raid™ serial ATA RAID management software can also be found on the B&R website.
Information:
Required drivers can only be downloaded from the B&R website, not from manufacturer websites.
3.9.23.6 Configuration
For information about configuring a SATA RAID set, see 3 "Installation", section 8 "Configuring a SATA RAID set"
3.9.23.7 Replacing a HDD
A hard drive can be easily replaced in the event of an error when using the RAID1 (mirroring) configuration without
having to reinstall the system. The 500 GB 5MMHDD.0500-00 SATA HDD is available as a replacement hard disk.
For information about performing a replacement, see "Replacing a PCI SATA RAID hard disk in a RAID 1 set"