Installation • Installation
Chapter 3 Installation
Panel PC 800 User's Manual V1.30
149
Chapter 3 • Installation
1 Installation
Danger!
•
All supply voltage must be disconnected before removing device covers or components or
removing/installing accessories, hardware or cables.
•
The power cable must be disconnected from the device and from the voltage supply.
•
Before the device can be connected to the power supply and turned on, all covers, components,
accessories, hardware and cables must be installed or attached.
B&R Industrial PCs are best mounted in a wall cutout using the retaining clips or clamping blocks found on the
housing (designs may vary).
1.1 Important installation information
•
Environmental conditions must be taken into consideration.
•
When installed in an enclosed housing, enough space must be available for air to circulate sufficiently.
•
This device must be mounted to a flat, clean and burr-free surface.
•
This device is only certified for operation in closed rooms.
•
This device must not be subjected to direct sunlight.
•
Ventilation holes must not be covered.
•
This device must be mounted in one of the approved orientations.
•
The wall or control cabinet must be able to withstand four times the total weight of the device.
•
The flex radius of connected cables (DVI, SDL, USB, etc.) must not be exceeded.
•
This device must be mounted in a position that minimizes glare on the screen.
•
This device must be mounted in a position and orientation that make viewing as easy as possible for the
operator.
1.2 Installation with clamping blocks
C
la
m
pi
ng
le
ve
r
Spring
C
la
m
pi
ng
le
ve
r
Clamping lever
Plastic (PA6)
with springs
Close
Open
Plastic (PA6)
without springs
Close
Open
Clamping lever
Figure 66: Clamping blocks
Clamping blocks are designed to clamp a maximum thickness of 10 mm and minimum thickness of 2 mm.
A hex key (3 mm) is needed to tighten and loosen the screws. The maximum torque when tightening the clamp
is 0.5 Nm.