Appendix A • Mounting compatibility
374
Panel PC 800 User's Manual V1.30
15" Power Panel 500 devices are not 100% mounting compatible with Power Panel 100/200/300/400, Automation
Panel 900 and Panel PC 700 devices in the Vertical1 format. The Power Panel 500 devices require a cutout that
is 0.5 mm higher (top and bottom edge).
The larger cutout can be used for all devices under certain conditions:
•
When mounting, make sure that the PP100/200, PP300/400, AP900 and PPC700 devices are mounted as
close to the center of the cutout as possible. Failure to do so can prevent the retaining clips from holding
firmly, which means that a firm seal is no longer guaranteed with the gasket (IP65).
6.2.6 17" devices
Outer contour of device
Cutout for device
460 x 373 ±0.5
AP900/PPC700
477 x 390
8.5
8.5
8.5
8.5
Figure 239: Mounting compatibility - 17" device - Horizontal1
17" Automation Panel 900 devices are 100% mounting compatible with Panel PC 700 devices in the Horizontal1
format.
6.2.7 19" devices
Outer contour of device
Cutout for device
510 x 404 ±0.5
527 x 421
8.5
8.5
8.5
8.5
AP900/PPC700
PPC800
Figure 240: Mounting compatibility - 19" device - Horizontal1
19" Automation Panel 900, Panel PC 700 and Panel PC 800 are 100% mounting compatible in the Horizontal1
format.