Software • BIOS options
Chapter 4 Software
Panel PC 800 User's Manual V1.30
213
BIOS setting
Function
Configuration options
Effect
Force BIOS
Displays an additional part of BIOS
Add-on ROM display mode Sets the display mode for the ROM (during the
booting procedure)
Keep current
Displays BIOS information
Enabled
Pauses the system. The system pauses each
time an error occurs.
Halt on error
This option determines the system should re-
sume after a startup error during POST.
Disabled
Does not pause the system. All errors are ig-
nored.
Enabled
Displays the message
Hit 'DEL' message display Configures settings for the "Hit 'DEL'" message
Information:
The message is not displayed if "Quiet
boot" is enabled.
Disabled
Does not display the message
Enabled
Enables this function
Interrupt 19 capture
This function can be used to include BIOS inter-
ruptions.
Disabled
Disables this function
Enabled
Enables this function
PXE boot to LAN (ETH1)
Enables/disables the function to boot from LAN
(ETH1)
Disabled
Disables this function
Enabled
Enables this function
Slide-in 2 optional ROM
Enables/Disables optional ROM for a slide-in 2
drive
Disabled
Disables this function
Remain off
System remains off
Turn on
System powered on
Power loss control
Specifies whether the system should be on/off fol-
lowing power loss
Last state
Enables the previous state
Table 166: 945GME Boot menu - Configuration options
1.6 Security
Main Advanced Boot
Power Exit
Security
Security Settings
Hard Disk Security
Install or Change the
password.
Change User Password
Boot Sector Virus Protection [Disabled]
Hard Disk Security User Passwords
Select Screen
Hard Disk Security Master Passwords
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Supervisor Password :Not Installed
User Password :Not Installed
Change Supervisor Password
BIOS SETUP UTILITY
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
Figure 119: 945GME Security Menü
BIOS setting
Function
Configuration options
Effect
Supervisor password
Displays whether a supervisor password has
been set
None
-
User password
Displays whether a user password has been set
None
-
Change supervisor pass-
word
Function for entering/changing a supervisor
password. A supervisor password is necessary to
edit all BIOS settings.
Enter
Password entry
Change user password
Function for entering/changing a user password.
The user password allows the user to edit only
certain BIOS settings.
Enter
Password entry
Table 167: 945GME Security menu - Configuration options