AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 812 / 920

User's Manual 812 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
CLI: semi-att-transfer
[EnableSemiAttendedTransfer]

[0] Disable = (Default) Send REFER with the Replaces
header.

[1] Enable = Send CANCEL, and after a 487 response is
received, send REFER without the Replaces header.
Web: Blind
EMS: Blind Transfer
CLI: blind-transfer
[KeyBlindTransfer]
Defines the keypad sequence to activate blind transfer for
established Tel-to-IP calls. The Tel user can perform blind
transfer by dialing the KeyBlindTransfer digits, followed by a
transferee destination number.
After the KeyBlindTransfer DTMF digits sequence is dialed,
the current call is put on hold (using a Re-INVITE message), a
dial tone is played to the channel, and then the phone number
collection starts.
After the destination phone number is collected, it is sent to
the transferee in a SIP REFER request in a Refer-To header.
The call is then terminated and a confirmation tone is played
to the channel. If the phone number collection fails due to a
mismatch, a reorder tone is played to the channel.
EMS: Blind Transfer Disconnect
Timeout
CLI: blind-xfer-disc-tmo
[BlindTransferDisconnectTimeout]
Defines the duration (in milliseconds) for which the device
waits for a disconnection from the Tel side after the Blind
Transfer Code (KeyBlindTransfer) has been identified. When
this timer expires, a SIP REFER message is sent toward the
IP side. If this parameter is set to 0, the REFER message is
immediately sent.
The valid value range is 0 to 1,000,000. The default is 0.
Web: QSIG Path Replacement Mode
CLI: qsig-path-replacement-md
[QSIGPathReplacementMode] Enables QSIG transfer for IP-to-Tel and Tel-to-IP calls.

[0] IP2QSIGTransfer = (Default) Enables IP-to-QSIG
transfer.

[1] QSIG2IPTransfer = Enables QSIG-to-IP transfer.
CLI: replace-tel2ip-calnum-to
[ReplaceTel2IPCallingNumTimeout] Defines the maximum duration (timeout) to wait between call
Setup and Facility with Redirecting Number for replacing the
calling number (for Tel-to-IP calls).
The valid value range is 0 to 10,000 msec. The default is 0.
The interworking of the received Setup message to a SIP
INVITE is suspended when this parameter is set to any value
greater than 0. This means that the redirecting number in the
Setup message is not checked. When a subsequent Facility
with Call Transfer Complete/Update is received with a non-
empty Redirection Number, the Calling Number is replaced
with the received redirect number in the sent INVITE
message.
If the timeout expires, the device sends the INVITE without
changing the calling number.
Notes:

The suspension of the INVITE message occurs for all calls.

This parameter is applicable to QSIG.
Web: IP2IP Transfer Mode
CLI: ip2ip-transfer-mode
[IP2IPTransfermode] Determines the interworking of incoming mid-call SIP REFER
messages to outgoing REFER messages, for calls pertaining
to the IP-to-IP application.

[0] Disable = (Default) Upon receipt of a REFER message,
the device sends an INVITE to the refer-to destination with
or without the Replaces header.