AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 809 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 809 Mediant 500 E-SBC
Parameter Description

For this feature to function, you also need to enable the
device to include the P-Asserted-Identity header in
180/200 OK responses, by setting the AssertedIDMode
parameter to
Add P-Asserted-Identity.

If the received Q.931 Connect message contains a
Connected Party Number, this number is used in the P-
Asserted-Identity header in 200 OK response.

This parameter is applicable to ISDN and CAS.
Web: Caller ID Transport Type
EMS: Transport Type
CLI: caller-ID-transport-type
[CallerIDTransportType]
Determines the device's behavior for Caller ID detection.

[0] Disable = The caller ID signal is not detected -
DTMF digits remain in the voice stream.

[1] Relay = (Currently not applicable.)

[3] Mute = (Default) The caller ID signal is detected
from the Tel/PSTN side and then erased from the voice
stream.
54.10.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 54-42: Call Waiting Parameters
Parameter Description
Web/EMS: Enable Call Waiting
CLI: call-waiting
[EnableCallWaiting]
Enables the Call Waiting feature.

[0] Disable

[1] Enable (Default)
For digital interfaces: If enabled and the device initiates a Tel-to-IP
call to a destination that is busy, it plays a call waiting ringback
tone to the caller. The tone is played only if the destination returns
a 182 "Queued" SIP response.
Note: The device's Call Progress Tones (CPT) file must include a
Call Waiting ringback tone.
EMS: Send 180 For Call Waiting
[Send180ForCallWaiting]
Determines the SIP response code for indicating Call Waiting.

[0] = (Default) Use 182 Queued response to indicate call
waiting.

[1] = Use 180 Ringing response to indicate call waiting.