AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 698 / 920

User's Manual 698 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description

If the supplied key does not pass validation of the 12 Hex
values input or it is set with the default value, the engine ID
is generated according to RFC 3411.
Web: SNMP Trap Destination Parameters
EMS: Network > SNMP Managers Table
CLI: configure system/snmp trap destination
Note: Up to five SNMP trap managers can be defined.
SNMP Manager
[SNMPManagerIsUsed_x]
Determines the validity of the parameters (IP address and port
number) of the corresponding SNMP Manager used to receive
SNMP traps.

[0] (Check box cleared) = Disabled (default)

[1] (Check box selected) = Enabled
Web: IP Address
EMS: Address
CLI: ip-address
[SNMPManagerTableIP_x]
Defines the IP address of the remote host used as an SNMP
Manager. The device sends SNMP traps to this IP address.
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Web: Trap Port
EMS: Port
CLI: port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager. The
device sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default port
is 162.
Web: Trap Enable
CLI: send-trap
[SNMPManagerTrapSendingEna
ble_x]
Enables the sending of traps to the corresponding SNMP
manager.

[0] Disable = Sending is disabled.

[1] Enable = (Default) Sending is enabled.
Web: Trap User
CLI: trap-user
[SNMPManagerTrapUser_x]
Defines the SNMPv3 USM user or SNMPv2 user to associate
with the trap destination. This determines the trap format,
authentication level, and encryption level. By default, it is
associated with the SNMPv2 user (SNMP trap community
string).
The valid value is a string.
Web: Trap Manager Host Name
CLI: manager-host-name
[SNMPTrapManagerHostName]
Defines an FQDN of the remote host used as an SNMP
manager. The resolved IP address replaces the last entry in the
Trap Manager table (defined by the SNMPManagerTableIP
parameter) and the last trap manager entry of
snmpTargetAddrTable in the snmpTargetMIB. For example:
'mngr.corp.mycompany.com'.
The valid range is a string of up to 99 characters.
SNMP Community String Parameters
Community String - Read Only
configure system > snmp > ro-
community-string
Defines a read-only SNMP community string. Up to five read-
only community strings can be configured.
The valid value is a string of up to 19 characters that can