AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 853 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 853 Mediant 500 E-SBC
Parameter Description
expires.
The valid value range is 0 to 10 seconds, where 0 (default)
disables this feature.
Notes:

This parameter is applicable to IP-to-Tel and Tel-to-IP calls.

This parameter is applicable only to ISDN and CAS protocols.
Web: Send Digit Pattern on
Connect
EMS: Connect Code
CLI: digit-pttrn-on-conn
[TelConnectCode]
Defines a digit pattern to send to the Tel side after a SIP 200 OK
is received from the IP side. The digit pattern is a user-defined
DTMF sequence that is used to indicate an answer signal (e.g.,
for billing).
The valid range is 1 to 8 characters.
Note: This parameter is applicable only to CAS.
Web: Disconnect on Broken
Connection
EMS: Disconnect Calls on
Broken Connection
CLI: disc-broken-conn
[DisconnectOnBrokenConnecti
on]
Global parameter that enables the device to release calls if RTP
packets are not received within a user-defined timeout
(configured by the BrokenConnectionEventTimeout parameter).
You can also configure this functionality per specific calls, using
IP Profiles (IpProfile_DisconnectOnBrokenConnection). For a
detailed description of this parameter and for configuring this
functionality in the IP Profile table, see ''Configuring IP Profiles''
on page
304 .
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
Web: Broken Connection
Timeout
EMS: Broken Connection Event
Timeout
CLI: broken-connection-event-
timeout
[BrokenConnectionEventTimeo
ut]
Defines the time period (in 100-msec units) after which a call is
disconnected if an RTP packet is not received.
The valid range is from 3 (i.e., 300 msec) to an unlimited value
(e.g., 20 hours). The default is 100 (i.e., 10000 msec or 10
seconds).
Notes:

This parameter is applicable only if the parameter
DisconnectOnBrokenConnection is set to 1.

Currently, this feature functions only if Silence Suppression is
disabled.
Web: Disconnect Call on Silence
Detection
EMS: Disconnect On Detection
Of Silence
CLI: disc-on-silence-det
[EnableSilenceDisconnect]
Determines whether calls are disconnected after detection of
silence.

[1] Yes = The device disconnects calls in which silence occurs
(in both call directions) for more than a user-defined time.

[0] No = (Default) Call is not disconnected when silence is
detected.
The silence duration can be configured by the
FarEndDisconnectSilencePeriod parameter (default 120).
Note: To activate this feature, set the parameters
EnableSilenceCompression and
FarEndDisconnectSilenceMethod to 1.
Web: Silence Detection Period
[sec]
EMS: Silence Detection Time Out
[FarEndDisconnectSilencePeri
od]
Defines the duration of the silence period (in seconds) after which
the call is disconnected.
The range is 10 to 28,800 (i.e., 8 hours). The default is 120
seconds.
Note: For this parameter to take effect, a device reset is required.
Web: Silence Detection Method Determines the silence detection method.