AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 112 / 920

User's Manual 112 Document #: LTRT-10437
Mediant 500 E-SBC
The following procedure describes how to configure Tx/Rx mode in the Web interface. You
can also configure this using the table ini file parameter, EtherGroupTable or CLI
command, configure voip/ether-group.
Notes:
•
Before you can re-assign a port to a different Ethernet Group, you must first
remove the port from its current Ethernet Group. To remove the port, either set the
'Member' field to
None or to a different port.
•
When implementing 1+1 Ethernet port redundancy, please adhere to the following
guidelines:
√
As all the ports have the same MAC address, you must connect each port
to a different Layer-2 switch.
√
Each port in the Ethernet Group (port pair) must be connected to a different
switch, but in the same subnet.

To configure Ethernet Groups:
1. Open the Ethernet Group Settings page ( Configuration tab > VoIP menu > Network
> Ethernet Groups Table ).
2. If the port that you want to assign to a specific Ethernet Group is already associated
with another Ethernet Group, you must first remove the port from the currently
associated Ethernet Group before you can associate it with the desired Ethernet
Group:
a. Select the Ethernet Group to which the port is currently associated, and then click
Edit ; the following dialog box appears:
Figure 12-3: Ethernet Group Settings Page
b. Set the 'Member 1' or 'Member 2' field (depending on where the port appears) to
None (or to a different port).
c. Click Submit ; the port is removed from the Ethernet Group.
3. Select the Ethernet Group that you want to configure and associate a port(s), and then
click
Edit .
4. Configure the Ethernet Group according to the parameters described in the table
below.
5. Click Submit , and then save ("burn") your settings to flash memory.