AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 768 / 920

User's Manual 768 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description

'8' is the B-channel

'IP=192.168.13.1' is the device's IP address
Web/EMS: Progress
Indicator to IP
CLI: prog-ind-2ip
[ProgressIndicator2IP] Global parameter that defines the progress indicator (PI) sent to the IP.
You can also configure this functionality per specific calls, using IP
Profiles (IpProfile_ProgressIndicator2IP) or Tel Profiles. For a detailed
description of this parameter and for configuring this functionality in the
IP Profile table, see Configuring IP Profiles on page
304 or in the Tel
Profile table, see Configuring Tel Profiles on page 301 .
Note: If this functionality is configured for a specific profile, the settings
of this global parameter is ignored for calls associated with the profile.
[EnableRekeyAfter181] Enables the device to send a re-INVITE with a new (different) SRTP
key (in the SDP) if a SIP 181 response is received ("call is being
forwarded"). The re-INVITE is sent immediately upon receipt of the 200
OK (when the call is answered).

[0] = Disable (default)

[1] = Enable
Note: This parameter is applicable only if SRTP is used.
[NumberOfActiveDialogs] Defines the maximum number of concurrent, outgoing SIP REGISTER
dialogs. This parameter is used to control the registration rate.
The valid range is 1 to 20. The default is 20.
Notes:

Once a 200 OK is received in response to a REGISTER message,
the REGISTER message is not considered in this maximum count
limit.

This parameter applies only to outgoing REGISTER messages (i.e.,
incoming is unlimited).
EMS: Transparent Coder On
Data Call
[TransparentCoderOnDataC
all]

[0] = (Default) Only use coders from the coder list.

[1] = Use Transparent coder for data calls (according to RFC
4040).
The Transparent coder can be used on data calls. When the device
receives a Setup message from the ISDN with 'TransferCapabilities =
data', it can initiate a call using the coder 'Transparent' (even if the
coder is not included in the coder list).
The initiated INVITE includes the following SDP attribute:
a=rtpmap:97 CLEARMODE/8000
The default payload type is set according to the CodersGroup
parameter. If the Transparent coder is not defined, the default is set to
56. The payload type is negotiated with the remote side, i.e., the
selected payload type is according to the remote side selection. The
receiving device must include the 'Transparent' coder in its coder list.
Web: IP to IP Application
CLI: enable-ip2ip
[EnableIP2IPApplication] Enables the IP-to-IP Call Routing application.

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
[IP2IPTranscodingMode] Note: This parameter is no longer valid and must not be used.
Defines the voice transcoding mode (media negotiation) between two
user agents for the IP-to-IP application. This parameter must always
be set to 1 when using the IP-to-IP application.

[0] Only if Required = Do not force transcoding. Many of the media
settings (such as gain control) are not implemented on the voice