AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 557 / 920

User's Manual 39. Software Upgrade
Version 6.8 557 Mediant 500 E-SBC
39.1.4.2 Dialing Plans for Digit Collection
The device enables you to configure multiple dialing plans in an external Dial Plan file,
which can be installed on the device. If a Dial Plan file is implemented, the device first
attempts to locate a matching digit pattern in a specified Dial Plan index listed in the file
and if not found, attempts to locate a matching digit pattern in the Digit Map. The Digit Map
is configured by the 'Digit Mapping Rules' parameter, located in the DTMF & Dialing page
(
Configuration tab > VoIP menu > GW and IP to IP > DTMF and Supplementary >
DTMF & Dialing ).
The Dial Plan is used for the following:

ISDN Overlap Dialing (Tel-to-IP calls): The file allows the device to know when digit
collection ends, after which it starts sending all the collected (or dialed) digits in the
outgoing INVITE message. This also provides enhanced digit mapping.

CAS E1 MF-CR2 (Tel-to-IP calls): Useful for E1 MF-CR2 variants that do not support
I-15 terminating digits (e.g., in Brazil and Mexico). The Dial Plan file allows the device
to detect end-of-dialing in such cases. The CasTrunkDialPlanName_x ini file
parameter determines which dial plan (in the Dial Plan file) to use for a specific trunk.
Notes:
•
To use the Dial Plan file, you must also use a special CAS .dat file that supports
this feature. For more information, contact your AudioCodes sales representative.
•
For E1 CAS MFC-R2 variants, which don't support terminating digit for the called
party number, usually I-15, the Dial Plan file and the DigitMapping parameter are
ignored. Instead, you can define a Dial Plan template per trunk using the
parameter CasTrunkDialPlanName_x.
The Dial Plan file can contain up to 8 Dial Plans (Dial Plan indices), with a total of up to
8,000 dialing rules (lines) of distinct prefixes (e.g. area codes, international telephone
number patterns) for the PSTN to which the device is connected.
The Dial Plan file is created in a textual ini file with the following syntax:
<called number prefix>,<total digits to wait before sending>

Each new Dial Plan index begins with a Dial Plan name enclosed in square brackets
"[...]" on a new line.

Each line under the Dial Plan index defines a dialing prefix and the number of digits
expected to follow that prefix. The prefix is separated by a comma "," from the number
of additional digits.

The prefix can include numerical ranges in the format [x-y], as well as multiple
numerical ranges [n-m][x-y] (no comma between them).

The prefix can include the asterisk "*" and number "#" signs.

The number of additional digits can include a numerical range in the format x-y.

Empty lines are ignored.

Lines beginning with a semicolon ";" are ignored. The semicolon can be used for
comments.
Below shows an example of a Dial Plan file (in ini -file format), containing two dial plans:
; Example of dial-plan configuration.
; This file contains two dial plans:
[ PLAN1 ]
; Destination cellular area codes 052, 054, and 050 with 8 digits.
052,8
054,8
050,8