AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 530 / 920

User's Manual 530 Document #: LTRT-10437
Mediant 500 E-SBC
3. If the connection is through a switch, the packets of both interfaces should generally
be untagged. In such a scenario, set the Native VLAN ID of each Ethernet Port Group
so that it is the same as the VLAN ID set for each interface assigned to that Ethernet
Port Group. The Native VLAN ID is configured in the Physical Ports Settings page
(see ''Configuring Physical Ethernet Ports'' on page
109 ). The figure below shows an
example whereby the Native VLAN IDs of the Ethernet Port Groups are set to the
same VLAN IDs of the interfaces using these Ethernet Port Groups:
Figure 32-5: Native VLAN for Ethernet Port Groups of Maintenance and Other Interfaces
4. Set the Ethernet port Tx / Rx mode of the Ethernet Port Group used by the
Maintenance interface. This is configured in the Ethernet Group Settings page (see
''Configuring Ethernet Ports'' on page
111 ). The port mode depends on the type of
Maintenance connection between the devices, as described in ''Network Topology
Types and Rx/Tx Ethernet Port Group Settings'' on page
527 .
5. Configure the HA parameters in the HA Settings page ( Configuration tab > System
menu > HA Settings ):
Figure 32-6: HA Settings Page
a. In the 'HA Remote Address' field, enter the Maintenance IP address of the
second device.
b. Enable the Revertive mode by setting the 'HA Revertive' parameter to Enable
and then setting the priority level of this device in the 'HA Priority' field. Make sure
that the priority level of this device is higher than the priority level of the
redundant device (configured in Step 2: Configure the Second Device on page
531 ).
6. Burn the configuration to flash without a reset.
7. Power down the device.
8. Continue to ''Step 2: Configure the Second Device'' on page 531 for configuring the
second device.