Associated Research 620L, Руководство по эксплуатации и обслуживанию

Страница: 84 / 223

78
COMMAND DESCRIPTION VALUE
FL < file number > File Load file number = 1-50
FD File Delete Active selected File
FD < file number >
File Delete by
Number
file number = 1-50
FS File Save Active selected File
FSA {< file
number >,< file
name >}
File Save-as file number = 1-50, file name =
Valid ASCII (1)
maximum 11 characters
FM {1|0} File Memory Link 1=On, 0=Off
FM?
FN {< file
number >,< file
name >}
File New file number = 1-50, file name =
Valid ASCII (1)
maximum 11 characters
SS < step number > Step Select step number = 1-30
ADD
<test,
p1,p2,p3…>
Adds all parameters
SAR Step Add RUN test
SAL Step Add LLT test
SD Step Delete Active selected Step
SD < step number > Step Delete by
Number step number = 1-30
SP < prompt
message >
Step Prompt Create prompt message = Valid ASCII
(1)
maximum 32 characters
SP Step Prompt Delete
SF {1|0} Step Fail Stop 1=On, 0=Off
(1) "Valid ASCII" is the character set that is available from the front panel LCD user
interface. Consisting of upper case alphabet (A-Z), numbers (0-9) and decimal point
(.), asterisk (*), dash (-), under bar (_), tilde (~) and space (SP).
FL <memory number>
Load a file by memory number from non-volatile memory into random access memory
RAM.
FD
Deletes the file loaded into RAM from the non-volatile memory space as well as RAM.
A new file must be loaded before and tests can be run.
The “FD” command writes to the non-volatile memory of the
instrument. The non-volatile memory has a limited write cycle
life. Therefore, for programmers who wish to send all
parameters before executing each test, the “FD” command should not be used.