AMD2000 Series - Servo Drive - User Manual
176
DS619-0-00-0019 - Rev 0
ANCA Motion
12.17
EtherCAT®
17
Conformance Marking
An EtherCAT device conformance mark is attached to each drive in order to verify that the
unit has been tested for compliance with the EtherCAT marking, indicator and performance
guidelines covered by the ETG standards listed in section 12.16. Future drive revisions
intend to achieve “Conformance tested” marking by independent verification through an
externally registered body.
12.18
CE Marking
A CE mark is attached to each drive in order to verify that the unit meets the relevant Low
Voltage and Electromagnetic Compliance (EMC) directives of the European Union.
12.18.11
Compliance with the European EMC Directive is
achieved via EN 61800-3
The object of this standard (61800-3) is to define the limits and test methods for a Power Drive System (PDS)
according to its intended use, whether residential, commercial or industrial. The standard sets out immunity
requirements and requirements for electromagnetic emissions as minimums within these different environments.
The AMD2000 (both 3A and 9A) are intended for use as Category 3 PDS, and have been tested and certified to
comply for use within what 61800-3 defines as the second environment. The AMD2000 3A and 9A comply with
the standard with the following provisions:
1. The motor and control cables are selected according the specifications given in this manual.
2. The drives are installed and maintained according to the instructions given in this manual.
3. The maximum cable lengths are 15 metres.
Warning:
A drive of category C3 is not intended to be used on a low-voltage public network which supplies
domestic premises. Radio frequency interference is expected if the drive is used on such a network
Definitions
12.18.11.1
First environment
Environment that includes domestic premises, it also includes establishments directly
connected without intermediate transformers to a low-voltage power supply network which
supplies buildings used for domestic purposes.
Second environment
Environment that includes all establishments other than those directly connected to a low-
voltage power supply network which supplies buildings used for domestic purposes.
Category C3 Power Drive System
Category 3 is for a PDS of rated voltage less than 1000 V, intended for use in the second
environment and not intended for use in the first environment.
12.18.12
Compliance with the European Low Voltage Directive is
achieved via EN 61800-5-1
The object of this standard (61800-5-1) is to specify requirements for adjustable speed Power Drive Systems
(PDS) or their elements with respect to electrical, thermal and energy safety considerations. The AMD2000 (both
17
EtherCAT® is a registered trademark and patented technology, licensed by Beckhoff Automation GmbH, Germany
