ActionTec V2000H, Руководство пользователя

Страница: 28 / 130

Page 28 of 130
Figure 27: Impact Tools
Running Jumpers in the SAC/JWI

Insert the jumper from top of MS2 modular block and run it straight down.

Ensure tip color is at the left of marking and ring color is at the right of marking.

Using the MS2 impact tool you can punch down the jumper by lining up with the binding post.

Follow the existing path as other jumpers.

Do not splice or user existing jumper, run a new one instead.

DO NOT MAKE YOUR OWN PATH!!

Ensure jumpers are ran through the rings inside the SAC.

Binding post 1 to 12 must enter and exit from the Left.

Binding post 13 to 25 must enter and exit from the Right.

Match the MS2 impact tool with the MS2 modular block.

Angle the MS2 impact tool 45 degree, the way the MS2 modular block is.

Punch down 1 conductor at a time.

The wire will be cut off.

If there is a cap on there, please ensure it is closed after you are done.

Some SAC boxes you will find red caps on a pair, these are special circuits and should not be touched
unless you are the special circuits technician.

Special circuits can be – ISDN T1, PRI, Channel banks, etc.